|
Benefits Decouples tiling from timber substrate helping prevent tile cracking
- Levels off a floor where Maxxus deck (22mm thick) abuts 18mm boards or plywood
- Eliminates over-boarding with plywood
- Suitable for smooth concrete or timber
A revolutionary solution for fixing tiles to timber or plywood floors.
Preventing problems of tile damage by reducing the effects of timber shrinkage, warping and rotting.
Easy to cut and install with a self-adhesive backing.
Size:
1.2m sq pack (4 sheets 600 x 500mm)
Thickness:
2mm mesh
Instructions for Use:
A - Basic Method of Decoupling Only
- Peel off the backing paper
- Apply to a timber, plywood or concrete floor in a "brick" pattern with staggered joints. Use scissors, side-cutter or sharp knife to cuts sheets to size
- Apply tile adhesive into mesh to a depth of 8-10mm and comb through with a 6mm notched trowel over a small area. Firmly press tile into place.
|
Back
B - Wetroom method using Lastogum and/or electric UFH
- Peel off the backing paper
- Apply to a timber, plywood or concrete floor in a "brick" pattern with staggered joints. Use scissors, side-cutter or sharp knife to cuts sheets to size
- Brush Lastogum over walls and floor
- If using UFH apply the cable now. Seal the cables by pouring over a latex screed or carefully laying 3mm tile adhesive. Wait to dry
- Apply tile adhesive into mesh to a depth of 8-10mm and comb through with a 6mm notched trowel over a small area. Take a tile and butter the reverse with a solid bed of adhesive. Firmly press the tile into place - this is the solid-bed method. It eliminates channels and cavities that may cause tracking of water. Continue tiling.
Notes
Use a bag powder flexible tile adhesive
In non-wetroom areas it is not necessary to butter rear of tile as the channels within the adhesive will not be detrimental to water tracking.
|
